How to make a fabric rose

It's the last stiffened fabric project and then I'm moving on! I wanted to try an oversized, realistic fabric rose just for fun.

Make a template with six petals. I traced around a dinner plate and a small bowl on the back of some ugly wrapping paper. (Tip: if the paper is too curly, iron it flat and your life will be better.) I've included my feet so you can admire my cute socks.

Prepare some stiffened fabric. See here for how I did this. My fabric pieces were too big to lay flat in my microwave this time, so I draped each piece over a couple drinking glasses and nuked them one by one. The fabric came out stiffened in a odd shape, of course, but ironed flat easily.

Using the template, cut three flower shapes from the prepared fabric. Grab a shape and fold it in half to make a crease between petals. Open, rotate the flower, and repeat twice more until six creases radiate from the center.

In the first flower, cut a slit along one of the fold lines to the center. In the second flower, cut out one petal segment. In the third flower, cut out a piece with two petal segments. Save these cutouts; they'll form the center of the rose.

On each flower, overlap the two petals adjacent to the slit and secure with a little glue. (I used Aleene's OK To Wash-It Fabric Glue.)

While they're drying, curl the double-petal and single-petal cutouts. Heat each petal with an iron and roll the rounded edge back with your fingers. When it cools, heat the triangular point of the petal and roll it into a cone shape that's rose-like. This part is tricky! I had to iron the petals flat and start over a few times until I had something reasonable. The one-petal piece should be able to fit inside the two-petal piece when you're done.

Heat the remaining flower petals one at a time with your iron and curl the edges back.

At this point I stacked the pieces to see if they looked nice. Yes! But I decided a flat bottom for this flower might be more useful.

So I cut off the point. (If you're going to do this, I'd suggest trimming when the pieces are still flat: fold them into a cone shape and snip off the points before you glue.)

I hot glued the petals together at the base, then added a felt circle to hide the trimmed ends. I could see these as DIY wedding decorations, attached to curtain tie backs, used in romantic centerpieces, or gathering dust in my box of finished projects I have no idea what to do with.